Nylon filament with a diameter of 1.75 mm. This filament is stiff and very tough.
Material: Nylon / Polyamide (PA-6)
Weight (without spool): 750 g
Diameter: 3 mm
Spool size: 20 x 20 x 5,5 cm
Heated build plate: Not needed
Tips and Tricks:
- To make the nylon stick well to the build plate it is recommended to use blue masking tape with a thin layer of Elmer's glue on top.
- It is recommended to print this filament with temperature rates around 240-260°C and with a print speed of around 40-50 mm/s.
- Nylon absorbs moisture easily so remember to keep it dry, for instance in zip bags.